Subminiature Motion Sensor 5V CRN-5686 with sensitivity adjustment

   The motion sensor has one control element: the sensitivity of the motion sensor. The sensor is delivered with the control element set in the initial position - for the motion sensor it is the maximum sensitivity. The position of the adjustment element should be changed carefully. In case of problems, please adjust the control element in the starting position.

   The sensor has three contacts. Make sure to connect the power supply and controller input with great attention. Misconnection of the power supply or controller input will damage both devices! Plug wires from the controller: + 5V power supply from controller output +5V, signal cable connected to the controller input and minus 12V power supply (GND) to the soldered plug. The connection should be made as described on the socket mounted on the sensor. 

   Connect the sensors to the controller only after checking whether the controller works properly, ie if the animation lights up correctly after pressing the buttons on the housing.  If the controller works incorrectly, we again adjust the setting and possibly the angle of view of the sensors.